Code Search

Please fill the "Code Box" to find engine fault code.

Car Models :

Please select your car.

How To Clear Check Engine Lights ?

Ways to clear check engine light on car panel.

Check Engine Light Dictionary

Ways to clear check engine light on car panel.

U017E Engine Trouble Code

Meaning of U017E engine trouble code is a kind of network trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

U017E Fault Symptoms :

Check engine light comes on
Engine stalling or misfiring
Engine performance issues
Car not starting

If one of these reasons for U017E code is occuring now you should check U017E repair processes.
Now don't ask yourself; What should you do with U017E code ?
The solution is here :

U017E Possible Solution:

Disconnected, dirty or fouled spark plugs are common causes for engines that won't start. Spark plugs typically need to be replaced every season or 25 hours of use. You should also check that the spark plug gap is set properly. If your spark plugs look good, problems with your ignition system can also preventing a spark. These can range from a faulty spark plug lead, shorted kill switch or flywheel key damage.

U017E Code Meaning :

U	0	1	7	e
OBD-II Diagnostic Network (U) Trouble Code For Engine	Intake Valve Control Solenoid Circuit Low	Fuel Rail/System Pressure - Too High	Cylinder 10 Contribution/balance Fault

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

U017E OBD-II Diagnostic Network (U) Trouble Code Description

U017E engine trouble code is about .

Main reason For U017E Code

The reason of U017E OBD-II Engine Trouble Code is Fuel Rail/System Pressure - Too High.

U017E the main thing to check is to verify the operation of the VCT solenoid. You're looking for a sticking or stuck VCt solenoid valve caused by contamination. Refer to vehicle specific repair manual to perform component tests for the VCT unit.

	Example: 0140